From the post yesterday about “What do you 3d print?” here are the parts being used!
The most common question I get when I talk about the 3D printer project I am wrapping up on and just the hobby in general is “So what do you 3D print anyway?” or “What are you actually printing with … Continued
As part of my many parallel projects I am doing around the house (which have all converged at the same time) I finished our new home automation setup. As I mentioned in a previous post https://joekelly.co//diy/home-automation-wink-to-hubitat/ , the migration was … Continued
Now that the printer construction is wrapping up, I am deep in to testing the scripts, calibrations, and such to enable dual extruder printing. With IDEX setups, (dual independent extruders) calibration is much more difficult than standard “shared” single X … Continued
It’s been a couple week or so since I posted about the 3D printer. This is due to other projects and work getting in the way. But also because work on the printer in general is tapering off as its … Continued