Posted my Duet3D Duet and Duex electronics mount to Thingiverse

posted in: 3D Printing | 0
The Duet / Duex mount with cooling

As part of this project I plan to upload most of the designs and such to Thingiverse as the finishing of this project. The Duet and Duex mount I designed to go under the printer has been requested a few times so I posted it as its own thing on thingiverse today. Check it out here if you want it. I tested it today and with 2 fans at 50% it dropped the main chip temps of the Duet 10C in 20 seconds.

https://www.thingiverse.com/thing:3518015

Comments are closed.