As I am closing in on the work I planned to do on the bike I am building another list of stuff to do… Mainly based off of stuff I discovered yesterday and stuff pending on parts that are still coming in.
One of the main things I am going to be doing is lowering the bike ~ 1" This is done by rotating the rear eccentric adjuster 180deg, and then lowering the front forks equally. This should let me flat foot the bike a bit better. But as with everything, one small change results in a big amount of work.
The rear hugger on the bike sits VERY close to the wheel normally… so it needs to be shimmed up equally. Which will require some fabrication, washers, etc… Quite interested to see how this all turns out.
Leave a Reply